The only changes that I attempted after defaulting it was to attempt to configure the Access Restrictions for policies 2-20. I decided to default the router and see if it behaves the same way. They displayed in the pulldown box but when I clicked on the policy the page would not display the parameters for those policies. That's when I discovered that it wouldn't switch to the policy 2 or 3 (I use policy 1 through 3). (I always perform this check before placing the router into production). Right after upgrading to r47225 I checked all tabs/pages to verify that the configuration was the same as it was in the previous release. There is no way to make changes on policies 2-20 unless CLI commands are used. However, in the case of r47225, it refreshes the screen with Policy 1 instead of the that I selected (policy 2-20). When working, as in previous releases, is supposed to display that policy selected on the page so that one can make changes and then save & apply them.In the 'Policy' box, click on down arrow, and then click on the policy that you want to modify.Navigate to Access Restrictions > Wan Access.I tried build r47225 on a Netgear WNDR3700 with the same results as the other two routers.įor clarification, the way it is normally works is: Same result, only policy 1 can be displayed in web GUI. I upgraded via web the Netgear R8500 from build r47206 to r47256 using file netgear- r8500-webflash.bin. I also tried build r47256 with a Netgear R8500.

I upgraded, via web GUI, the Netgear R7000 from build r47225 to r47256 using netgear- r7000-webflash.bin.

The issue is also present in build r47256 for a Netgear R7000.

I verified that the same issue with r47225 is present on a Netgear R8500 that was web upgraded from r47182 to r47225 using netgear- r8500-webflash.bin. Let me know if you need additional log files uploaded. I did not connect the test unit to LAN because it failed my initial testing (no point in disrupting production environment). I've uploaded basic log files (identifying info altered) but I don't think that they apply. Same result from web upgrade and after defaulting via CLI and configuring from scratch. When selecting policies 2-20 in the pull down box it reverts back to policy 1. Access Restrictions > WAN Access Policy box.

R8500 dd wrt